东洲阻燃ZR-KFV22-0.5KV10X2.5线缆现货萝莉

东洲阻燃ZR-KFV22-0.5KV10X2.5线缆现货萝莉

Integrated stranded railway signal cable implementation standard GB/ t2476-1993. Railway signal cables are suitable for transmission of railway control signals, audio signals or fixed cables for fixed installation in rated voltage ac 500V or dc 1000V or below. Product name, model, specification and scope: plastic insulation and PVC sheathed railway signal cable PTYAH; PTYA; PZYA; PTYV; PTYY,; PTY22; PTY23; (PZY02; PZY03; PZY23 PZY22) 1/0.8mm (1/1.0mm) 2-48 core is suitable for railway signal communication, fire alarm signal, telegraph and other automatic device systems with rated voltage ac 500V or dc 1000V or below.
　　HYAC：铜芯实心聚烯烃绝缘自承式挡潮层聚乙烯护套市内通信电缆。HYA53：铜芯实心聚烯烃绝缘挡潮层聚乙烯护套钢塑带铠装聚乙烯护套市内通信电缆。HYAT53：铜芯实心聚烯烃绝缘填充式挡潮层聚乙烯护套钢塑带铠装聚乙烯护套市内通信电缆。

The main products of communication cables are HYA, HYAC, HYAT, HYAT53 and HYA53

　　四、电力电缆安装注意事项、使用特性及运行敷设条件1、电力电缆安装注意事项电缆与热力管道平行安装时保持2m的距离，交叉时应保持0.5m。电缆与其它管道平行或交叉安装时均要保持0.5m的距离。电缆直埋安装时，1-35KV电缆直埋深度不小于0.7m。



Insulation resistance: each conductor and the rest of the grounding wire core, the control cable is more than 10000 m Ω. Km, more than 3000 m Ω HYAT cable. Km.

实时性的保证为保证实时性，要求轮询表包含每个从站号不能少于一次，这样在周期轮询时，每个从站在一个周期中至少有一次机会取得总线使用权，从而保证了每个站的基本实时性。对于实时性要求比较高的站，可以在轮询表中让其从机号多出现几次，这样就用静态的方式赋予该站较高的通信优先权。在有些主从总线中轮询表法与中断法结合使用，让紧急任务可以打断正常的周期轮询而插入，获得优先服务，这就是用动态赋予某项紧急任务以较高优先权。

　　②短路时（长持续时间不超过5秒）电缆导体的高温度不超过250℃。使用特征：●工频额定电压Uo/U为3.6/6KV-26/35KV。●电缆导体的允许长期高工作温度为90℃。●短路时（长持续时间不超过5s）电缆导体的高温度不超过250℃。

　　本厂专业生产电力电缆，YJV,YJVR,RVV质量保证不亏方，外护套质量要求高电力电缆的使用至今已有百余年历史。1879年，美国发明家T.A.在铜棒上包绕黄麻并将其穿入铁管内，然后填充沥青混合物制成电缆。
　　（防水）HYAT通信电缆介绍：（直埋/管道/架空）内导体线径（mm）：0.40、0.50、0.60、0.70、0.80、0.90 对数（对）：5—3000宽带型/产品用途：适用于远程光网络单元到用户之间的传输系统，以及大楼布线系统中楼宇间传输的子系统。

Crane or forklift should be used for the loading and unloading of cables. It is forbidden to run flat or lay flat. For installation of large cables, cable laying cart should be used to avoid external damage or abrasion caused by manual dragging. If the cable cannot be laid in time for some reason, it should be stored in a dry place to prevent sunlight from exploding and water entering the end of the cable. Note: the installation of wire and cable should be familiar with the performance of wire and cable installation personnel or full-time technical personnel, if there are still unclear matters, ball related technical department or technical department of our factory.



　　MHYBV(HUYBV)矿用聚乙烯绝缘、镀锌钢丝编织铠装、阻燃聚氯乙烯护套通信电缆。MHYAV(HUYAV)矿用聚乙烯绝缘、铝/聚乙烯粘结护层、阻燃聚氯乙烯护套通信电缆。MHYA32(HUYA32)矿用聚乙烯绝缘、铝/聚乙烯粘结护层、镀锌钢丝铠装、阻燃聚氯乙烯护套通信电缆。

　　电缆导体长期工作温度不超过+70℃，电缆敷设温度不低于0℃，电缆弯曲半径不小于电缆外径的10倍。 NHA—KVV适用范围：同NHB—KVV，用于要求耐火较为苛刻的场所。 NHB—KVV22适用范围：同NHB—KVV，用于能承受机械外力的场所，电缆弯曲半径不小于电缆外径的15倍。

作业条件及现场准备工作箱体安装完毕。箱内空开、配线导线、配线扎带等已经准备完毕，并且符合设计图纸、配电箱安装要求。施工工序导轨安装要水平，并与盖板空开操作孔相匹配。空开安装空开安装时首先要注意箱盖上空开安装孔位置，保证空开位置在箱盖预留位置。其次开关安装时要从左向右排列，开关预留位应为一个整位。预留位一般放在配电箱右侧。第一排总空开与分空开之间有预留一下完整的整位用于第一排空开配线。导线选择零线颜色要采用蓝色。

This product is suitable for electronic computers with rated voltage of 500V or below, and cables for automatic connection, which have high requirements for protection. The k-type B low-density polymer with anti-oxidation property is adopted for the insulation of cable ground core. High insulation resistance, good voltage resistance, low dielectric coefficient and low dielectric loss temperature and variation of the medium can not only meet the requirement of transmission performance, but also ensure the service life of the cable. ? The cable is shielded for cross - circuit interference and external. The shielding requirements of cables are respectively adopted according to different conditions: the total shielding of the hinged cable, the total shielding of the hinged cable, and the total shielding of the hinged cable after the hinged cable is shielded. Shielding materials are round copper wire, copper belt, aluminum belt/plastic composite belt three. The insulating property of shielding pair and shielding pair. The transmission of the cable will not be affected if there is potential difference between shielding pair and shielding pair in use.

　　3）敷设电缆时的环境温度应不低于0℃，小弯曲半径应不小于电缆外径的10倍。2、产品使用特性：电缆的交流额定电压500V以下，电缆线芯的长期工作温度应不超过70℃。电缆允许弯曲关径应不小于电缆外径的6倍，敷设温度应不低于0℃。