低烟无卤线缆WDZ-KYJYPR3X0.75格宝清点击进入SYV-75-12电缆批发结实

低烟无卤线缆WDZ-KYJYPR3X0.75格宝清点击进入SYV-75-12电缆批发结实

　　导体：多股铜导体，符合GB/T3956第5类（等同于IEC60228.5）。绝缘：聚氯乙烯混合料（PVC）。护套：柔性聚氯乙烯混合料（PVC），灰色（RAL7001）。芯线标识：≤5芯，彩色芯线；黑色芯线白色数字编号，黄绿地线。



　　少4芯，大61芯6.产品功能铁路数字信号电缆具有传输模拟信号(1MHz)、数字信号(2Mbit/s)、额定电压交流750V或直流1100V及以下系统控制信息及电能的传输功能。适用于铁路信号自动闭塞系统、计轴、车站电码化、计算机连锁、微机监测、调度集中、调度监督、大功率电动转辙机等有关信号设备和控制装置之间传输控制信息、监测信息和电能。

In addition, once the halogenated body reacts with the water in the air, it will generate "halogenated hydrogen acid", which will seriously corrode e and buildings and cause "secondary disasters".

　　ZR-FV、ZR-KFF、KFFP、KFFP2、FV22 KFFR、KFFRP、KFFRP2、DJFPFP、DJFPFPR具体的型号有：ZR-KHF4、ZR-KHF4R、ZR-KHF4P、ZR-KHF4RP、KHF4、KHF4R、KHF4PR、KHF4P、KHF4RP、ZRC-KHF4、ZR-K。



Precautions for installation of power cables: keep 2m distance when the cable is installed in parallel with the thermal pipe, and 0.5m should be maintained when crossing. The cable shall be installed at a distance of 0.5m in parallel or across other pipelines. When the cable is directly buried and installed, the buried depth of 1-35kv cable is not less than 0.7m. When 10KV and below cables are installed in parallel, the net distance between them shall not be less than 0.1m and 10-35kv shall not be less than 0.25m. The distance of cross installation is not less than 0.5m. Cable laying temperature is not lower than 0 ℃, bending radius: multi-core cable or 15 (D + D), a single cable 20 or more (D + D), (D for cable diameter, D) for the conductor diameter. 6 kv and above cable joint: (1) installing a cable terminal head, must be stripped semiconductor electric shielding layer, operation shall not damage the insulation, should avoid mark uneven situation, when necessary use sand paper to grind; The shield end should be flat and the graphite layer (carbon particles) should be cleaned. (2) plastic cable end copper tape screened and armor must be good grounding, the short circuit also follow this principle, avoid unbalanced three-phase run ShiGang armoured end produce inductive electromotive force, and even "lighter" and accidents such as burning sheath. It is required to use my tinplate to braid copper wire for grounding lead. When connecting with the cable copper belt, it should be welded with chromium-iron tin. The shield of three-phase copper tape should be connected with ground wire respectively. Note that the shielded ground wire and steel armor ground wire should be separately drawn out and insulated from each other. The position of the welded ground wire should be as low as possible. Basic re for cable terminals and intermediate joints: a. good conductor connection; B. The insulation is reliable, and it is recommended to use irradiated cross-linked heat-shrinkable silicone rubber insulation materials; C. good sealing; D. sufficient mechanical strength to meet various operating conditions. The end of the cable must be used to prevent erosion of water and other corrosive materials, so as to prevent breakdown due to the aging of the insulation layer caused by water trees. Crane or forklift should be used for the loading and unloading of cables. It is forbidden to run flat or lay flat. For installation of large cables, cable laying cart should be used to avoid external damage or abrasion caused by manual dragging. If the cable cannot be laid in time for some reason, it should be stored in a dry place to prevent sunlight from exploding and water entering the end of the cable. Note: the installation of wire and cable should be done by the installation personnel or full-time technical personnel familiar with the performance of wire and cable. If there are still unclear matters, please consult the relevant technical department or the technical department of our factory.

模拟量数据采集值（PIWINT）转换为物理量（浮点数real）西门子plc通过采集通道采集到的值以整型（INT）型式保存在PIWx（PIW0）内，要换算为浮点型式的物理量需要经过以下两步。第一步：把INT转换为DINT，不用为为什么，就是精度精度精度。第二部：把DINT转换为REAL。这两步都很简单，。难点在于，把浮点数（REAL）转换为整形（INT），再通过PQW输出。物理量（浮点数real）转换为模拟量数据输出值（PQWINT）西门子PLC以整型（INT）型式输出模拟量（PQW0），一般的物理量都是浮点数型式，要把物理量换算为模拟量输出，需要经过以下两步。

　　5.耐火特性：符合IEC331规定符合GB12666.6规定火焰温度750℃火焰温度950℃-1000℃火焰温度750℃-800℃燃烧时间3h燃烧时间90min燃烧时间90min冷却时间21h附加电压额定电压附加电压额定电压附加电压额定电压附加电流3A附加电流3A附加电流3AA类B类6.敷设推荐的允。

Our new preferential treatment, cable packaging, cable with wooden shaft, freight all free,
　　DJYVP3R8X2X0.75 8X2X1.0 19×2×.52.5阻燃计算机电缆ZR-DJYVP22;ZR-DJYPV22;ZR-DJYPVP22DJYVP3R DJYVP3（R）1.使用标准（Q/NPDL本产品适用于电子计算机监控系统抗干扰性能要求较高的电缆，也适合于抗。


　　信号电缆分为：铁路信号电缆，PVC绝缘信号电缆，控制信号电缆，矿用信号电缆铁路信号电缆用途：适用于额定电压交流500V或直流1000V及以下传输铁路信号、音频信号或自动信号装置的控制电路，其中综合护套、铝护套铁路信号电缆具有一定的屏蔽性能，适宜于电气化区段或其它有强电干扰的地区敷设。

　　吊线和电缆用同一外护层，经济实用，安装敷设方便。在一30~C一60~C的环境条件下，电缆的机械和电气性能保持不变。结构：导线：退火裸铜线，铜线直径为0．32，0．4，0．50，0．60，0．70，0．80，0．90mm。

1. Ac rated voltage: U. /U (V series: 600/1000v, K series: 450/750v, B series: 450/750v) 2. The cable is the highest working temperature for a long time (1) the ene poly ethylene insulated and sheathed 坲 : 70 ℃ and 105 ℃ of two; Cross-linked polyethylene insulation: 90 ℃; (2) the fluorine plastic insulation and sheath: 220 ℃ and 260 ℃. 105 ℃ flame retardant poly (vinyl fluoride and fluorine plastic insulation sheath: 90 ℃ and 125 ℃. (3) low smoke low halogen flame retardant PVC insulated and sheathed: 70 ℃; Low smoke zero halogen flame retardant insulation and sheath: 90 ℃ and 125 ℃. 3. The lowest temperature: (1) flame retardant PVC insulated and sheathed: fixed installation - 40 ℃; The fixed installation - 15 ℃; (2) the fluorine plastic insulation and sheath: fixed installation - 60 ℃; The fixed installation - 20 ℃; 4. Cable temperature safety should not be below 0 ℃.

你会发现当你买了电动工具后，有的产品包装盒里会送2个小配件，有人知道它是碳刷，有人既不知道叫什么也不知道怎么用。而现在不管是海报宣传还是销售介绍，都将电动工具是无刷电机作为一大卖点，你要是问有什么区别，很多人只知道区别就是有无碳刷，那么碳刷到底是什么，它有什么作用，有刷电机与无刷电机之间有什么区别呢？碳刷人们也将它叫做电刷，主要在电气设备上广泛使用，是在一些电动机或者发电机的固定部分与旋转部分做信号或能量的传递，外形为长方形，还有金属线安装在弹簧内，碳刷是一种滑动接触件，所以容易磨损需要定期更换和清理磨损掉的积碳。

　　矿用信号电缆|MHYV矿用信号电缆|MHYVR矿用信号电缆|MHYVP矿用屏蔽信号电缆|MHY32矿用信号电缆|MHYVRP矿用屏蔽信号电缆｜矿用监测电缆 矿用信号电缆，适用于矿场作信号传输，可移动或固定使用。

　　公司在研制生产“通信电源用阻燃耐火软电缆”时，对电缆的绝缘、护套采用了低烟无卤、分解温度高、机械性能好的无卤聚合物材料，由于电缆不含卤化物和金属氧化物，在燃烧时不会产生有害气体和大量的烟雾，不存在会造成“二次灾害”的可能性，并且还具有良好的机械性能与电气性能，满足了电缆的使用要求，彻底改变了以往阻燃。



Oil filled telecommunication cable main electrical properties: 1. The oil filled cable dc resistance: 20 ℃, 0.4 148 0.5 or less & have spent 2. Insulation electric strength of oil-filled cable: 1min between conductors 1kv does not break the conductor and shield 1min& NBSP; 3 kv no breakdown 3. Oil-filled cable insulation resistance: each conductor and the rest of the grounding wire core, the HYAT cable is more than 3000 m Ω. Km. 4. Working capacitance of oil-filled cable: average value: 52 + / -2nf /km 5

　　以此类推25对色标排列：白兰、白橙、白绿、白棕、白灰、红兰、红橙、红绿、红棕、红灰、黑兰、黑橙、黑绿、黑棕、黑灰、黄兰、黄橙、黄绿、黄棕、黄灰、紫兰、紫橙、紫绿、紫棕、紫灰全塑市话电缆缆芯采用全色谱线对。