哈巴河KVV2X2.5控制电缆秀丽

哈巴河KVV2X2.5控制电缆秀丽

　　铠装双绞屏蔽型电缆ASTP-120Ω（forRS485&CAN）onepair18AWG，电缆外径12.3mm左右。可用于干扰严重、鼠害频繁以及有防雷、防爆要求的场所。使用时，建议铠装层两端接地，内层屏蔽一端接地。
　　普通双绞屏蔽型电缆STP-120Ω（forRS485&CAN）onepair20AWG，电缆外径7.7mm左右。适用于室内、管道及一般工业环境。使用时，屏蔽层一端接地。普通双绞屏蔽型电缆STP-120Ω（forRS485&CAN）onepair18AWG，电缆外径8.2mm左右。

　　2.绝缘颜色：3.3线芯为一根红色一根蓝色，0.85线芯为一根白色一根绿色，白色线芯外绕包一层铝箔。3.绝缘厚度：3.3线芯绝缘厚度为0.5，绝缘后外径为3.5毫米。0.85线芯绝缘厚度为0.7绝缘后外径为2.5毫米。

　　理论上RS485的传输距离能达到1200米，但实际应用中传输距离要小于1200米，具体长度受周围的环境影响。一般推荐如下：普通双绞屏蔽型电缆STP-120Ω（forRS485&CAN）onepair20AWG，电缆外径7.7mm左右。



Precautions for installation of power cables: keep 2m distance when the cable is installed in parallel with the thermal pipe, and 0.5m should be maintained when crossing. The cable shall be installed at a distance of 0.5m in parallel or across other pipelines. When the cable is directly buried and installed, the direct buried depth of 1-35kv cable is less than 0.7m. When 10KV and below cables are installed in parallel, the net distance between them shall not be less than 0.1m and 10-35kv shall not be less than 0.25m. The distance of cross installation is not less than 0.5m. Cable laying temperature lower than 0 ℃, bending radius: multi-core cable or 15 (D + D), a single cable 20 or more (D + D), (D for cable diameter, D) for the conductor diameter. ? 6KV and above cable connector:? When installing the terminal head of the cable, the semiconductor electrical shielding layer must be stripped off. During operation, the insulation shall not be damaged. The shield end should be flat and the graphite layer (carbon particles) should be clean. (2) plastic cable end copper tape screened and armor must be good grounding, the short circuit also follow this principle, avoid unbalanced three-phase run ShiGang armoured end produce inductive electromotive force, and even "lighter" and sheath and other accidents. It is required to use my tinplate to braid copper wire for grounding lead. When connecting with the cable copper belt, it should be welded with chromium-iron tin. ? The shield of three-phase copper tape should be connected with ground wire respectively. Note that the shielded ground wire and steel armor ground wire should be separately drawn out and insulated from each other. The position of the welded ground wire should be as low as possible. Basic re for cable terminals and intermediate joints: a. good conductor connection; B. The insulation is reliable, and it is recommended to use irradiated cross-linked heat-shrinkable silicone rubber insulation materials; C. good sealing; D. sufficient mechanical strength to meet various operating conditions. The end of the cable must be used to prevent water and other corrosive materials from corroding, in order to prevent the water tree caused by the aging of the insulation layer and breakdown. Crane or forklift should be used for the loading and unloading of cables. It is forbidden to run flat or lay flat. For installation of large cables, cable laying cart should be used to avoid external damage or abrasion caused by manual dragging. If the cable cannot be laid in time for some reason, it should be stored in a dry place to prevent sunlight from exploding and water entering the end of the cable. ? Note: the installation of wire and cable should be familiar with the performance of wire and cable installation personnel or full-time technical personnel, if there are still unclear matters, ball related technical department or technical department of our factory.

三相电动机是应用很广泛的电气旋转类工具，在电工维护保养过程中，我们经常会需要判断三相电动机三相绕组的首尾端，需要确保首尾端接线正确，因为三相绕组的首尾端接错后，会使绕组中电流方向反向，造成磁动势不平衡，三相电流严重不平衡，引起电动机振动和噪声，转速缓慢甚至不转。如不及时切断电源，还将造成绕组温度急剧上升而烧毁电动机。三相绕组首尾端的判别方法有以下几种。绕组串联法(又称灯泡法)。先用万用表将绕组的6根引线分成3个独立绕组，然后按-7所示的接法通以低压交流电源(所加电压应使绕组中的电流不超过额定值)。

　　产品介绍-矿用信号电缆|MHYV矿用信号电缆|MHYVR矿用信号电缆|MHYVP矿用信号电缆|MHY32矿用信号电缆|MHYVRP矿用信号电缆MHYVR（PUYVR）（1×21×42×23×24×25×26×28×210×2?）聚乙烯绝缘聚氯乙烯护套矿用信号电缆，用于矿场作普通信号传输，可移动使用。

　　使用条件1：使用温度（℃):-40～+602:相对温度:40℃时达98%3:安装敷设温度不低如:-15℃4:充许小弯曲半径:室内不小于5倍,室外10倍结构1:镀锡铜丝线芯2:聚氯乙烯绝缘3:薄膜绕包/镀锡铜丝编织网屏蔽4聚氯乙烯护套额定电压:300V/300V300V/500V采。
Call communication cable product features low cable of rated voltage: the minimum working temperature is not lower than 500 v low cable - 40 ℃. The highest long-term low cable allows working temperature: polyethylene insulation is not higher than 70 ℃; Cross-linked polyethylene insulation is not higher than 90 ℃. Low cable temperature: the minimum 0 ℃. Preheat if below minimum laying temperature. 's main electric cable performance: (l) 20 ℃ conductor dc resistance: 0.75 was no more than 26 / km; 2.0 was no greater than 9.8 Ω/km (2) 20 ℃ when the cable insulation resistance: 0.75 was not less than 300 m Ω • km; 2. Om Ω • Omm2 not small to 10 km. (3) voltage test between cable core and cable core, and between wire core and shield through ac 2500V/5min. (4) the working capacitance of the cable set shall not exceed 100pF/m when the test frequency is 1kHz. (5) the capacitance imbalance of the cable set shall not be greater than 250pF when the test frequency is lkHz and the cable length is 250Im. The combustion characteristics of the ending cable

　　本厂专业生产电力电缆，YJV,YJVR,RVV质量保证不亏方，外护套质量要求高电力电缆的使用至今已有百余年历史。1879年，美国发明家T.A.在铜棒上包绕黄麻并将其穿入铁管内，然后填充沥青混合物制成电缆。



　　 型号名称主要使用范围 HUVV铜芯聚氯乙烯绝缘聚氯乙烯扩套矿用电话电缆敷设在矿井中，一般场合 对绞式聚乙烯绝缘聚氯乙烯护套市内通信电缆型号 名称CPEV-S绞式聚乙烯绝缘聚氯乙烯护套市内通信电缆通信电缆-HYA电缆|HYA23电缆|HYA22电缆|HYA53电缆|室外电话线HYA53HYA53钢塑。

　　1.4电缆的允许弯曲半径：非铠装电缆应不小于电缆外径的10倍；铠装电缆应不小于电缆外径的15倍。RS232/RS-485通讯电缆信号线适用于EIARS-232/422通讯网络，是楼宇自控、工业控制网络、电力自动化等通讯网络的常用电缆型号。

三极管OC－813可以用П1П40П402等代替；晶体二极管0A625可以用任何型号的点接触型晶体二极管代替。在前面几种电路中，是用晶体三极管兼作检波和放大的。下面再介绍另一种经过实验的类似的电路（），供大家试制时参考。在电路中，单加了一只二极管专作检波。另外，用了两个输入回路，其中一个（L2C4）用以取得高频信号，另一个（L1C2）用以取得电源。两回路的线圈，各有若干抽头，以便选择合适的位置。各零件的数据及要求分别叙述如下。

　　6KV及以上电缆接头：①安装电缆终端头时，必须剥除半导体电屏蔽层，操作时不得损伤绝缘，应避免刀痕凹凸不平的情况，必要时用砂纸磨平；屏蔽端部应平整，并要把石墨层（碳粒）清除干净。②塑料绝缘电缆端头铜带屏蔽和钢铠必须良好接地，对短路也遵循这项原则，避免三相不平衡运行时钢铠端部产生感应电动势，甚至“打火”及燃烧护套等事故。

　　HJYJVP2ZR/SA成束阻燃型交联聚乙烯绝缘、聚氯乙烯护套、铜塑复合带绕包总屏蔽组合软结构呼叫通信电缆。HJYJVP3ZR/SA成束阻燃型交联聚乙烯绝缘、聚氯乙烯护套、铝塑复合带绕包总屏蔽组合软结构呼叫通信电缆。