扎兰屯铝塑综合护套线缆单薄

扎兰屯铝塑综合护套线缆单薄

　　 3、矿用控制电缆产品型号规格及范围： 矿用控制电缆型号 规格范围 使用场合MKVV,MKVVP,MKVVP2 0.5-10mm2,2-61芯 适用于弱电控制系统或强电磁场干扰区MKVV22,MKVV20 0.5-10mm2,4-61芯 MKVV32,MKVV30 0.5-10mm2,7-61芯 M。
　　6、使用特性：电缆导体的长期允许工作温度为70℃，电缆敷设温度应不低于0℃。电缆允许的弯曲半径：对有铠装或铜带屏蔽结构的电缆应不小于电缆外径的12倍。对有屏蔽层结构的软电缆，应不小于电缆外径的6倍。对无铠装层的电缆应不小于电缆外径的6倍。

Armored communication cable structure: 1. Basic cable: any filled and unfilled cable with single sheath or double sheath structure. 2. Armored communication cable mechanical protection layer: type 53 adopts 0.15mm thick corrugated steel belt, which is longitudinal wrapped on the basic cable and overlapped on both sides. The surface of the steel belt is coated with plastic to prevent corrosion and water intrusion. The type 23,22 has similar performance with double steel band wrapping. 3. Armored communication cable sheath: black high-molecular weight low-density polyethylene or polyvinyl chloride thin sheath. Sheath thickness may depend on the basic cable outer diameter. 4, identification and marking: cable appearance with permanent identification mark, tag, at no more than alternate 1 m intervals between 5, sheathed communication cable tag contents are: the diameter of wire, wire on the , type of cable, length, factory name and year of manufacture. 6. Armored communication cable electrical characteristics: the cable meets all the electrical re of the basic cable. 7. Cable length: mechanically protected cable is manufactured according to the standard length of the corresponding basic cable

1. Mine control cable execution: mt818-1999? 2. Mine flame retardant control cables: this product is applicable to ac rated voltage u0/u of 450/750v. And the following control and control circuits and the protection lines and the connection lines of the electrical instruments in the distribution e ? 3. Model specifications and scope of mine control cables:? Model of control cable for mine? Specification range? Using MKVV MKVVP, MKVVP2? 0.5 - was 10, 2-61 core? Suitable for weak current control or strong electromagnetic field area mkvvvv22, mkvvvvv20? 0.5 - was 10, 4-61 core? MKVV32, MKVV30? 0.5 - was 10, 7-61 core? MKVVR? 0.5-6 was, 2-61 core? MKVVRP? Was 0.5-4, 2-61 core? MKVVP22 MKVVP2-22? 1.5 - was 10, 4-61 core? MKVVP2-22-1? 1.5 - was 10, 4-61 core? Mainly used in 500KV substation and power plant distribution device and high electromagnetic field area mkvv-1, mkvvvvv22-1? 0.5 - was 10, 2-61 core? 4, using features: coal mine with control cable conductor long-term allowed working temperature is 70 ℃, the cable temperature under installation should not below 0 ℃. Permissible bending radius of control cables used in coal mines: for cables with armored or copper band shielding structures, the bending radius should not be less than 12 times of the outer diameter of the cables. For soft cable with shield layer structure, it should be no less than 6 times the outer diameter of the cable. The cable without armor layer should not be less than 6 times the outer diameter of the cable. ?



　　 b.周围环境温度：25℃ c.土壤热阻系数：1.0K•m/Wd.直埋深度：0.7m e.不同环境温度下载流量校正系数：环境温度（℃）1520253035校正系数1.111.051.000.940.88 ①电缆导体的长期允许工作温度：≤90℃ ②短路时（长持续时间不超过。

，M1=ON、M3=ON情况3修改M1值为OFF状态，M3值为ON状态，发现Y1=ON。以上可以发现执行线圈的双重输出，输出结果以下面的线圈为准。这时为什么呢，我们知道PLC程序指令顺序是按照从上到下，从左到右进行处理的，因此双线圈无论前面的状态如何都以后的线圈为输出结果。那么怎么改变上面的双线圈输出呢，采用并联的方法来实现：双线圈对策这样M3就不会影响M1的作用了，在写程序时候经常会遇到这种情况尤其是步数较多时，写后面的时候会忽略前面的输出，编译时三菱plc是不会报错的，怎么办，我们在下载程序对程序进行一次检查，点击工具程序检查：程序检查点击执行后会在下面的输出结果报错：程序检查结果这样就检查了双线圈输出避免了不必要的调试。

　　RVV电缆检验要求RVV是指多股铜芯软线,外观看线上的标识,皮层和线芯的比拟厚度.皮层一般是聚氯材料.铜芯是19股绞合.规格一般有1,1.5,2.5平方毫米.在看线的长度(一圈为100米),国标线95-100米,非标线90米左右。

Sheathed control cable insulation resistance: each conductor and the rest of the grounding wire core, control cable is more than 10000 m Ω. Km, more than 3000 m Ω HYAT cable. Km.
　　我国国家标准GB12666.6（等同IEC331）将耐火试验分A、B两种级别，A级火焰温度950~1000℃，持续供火时间90min，B级火焰温度750~800℃，持续供火时间90min，整个试验期间，试样应承受产品规定的额定电压值。

Model specification of frequency conversion cable: series code BP frequency conversion cable; Insulation code: YJ cross-linked polyinsulation; V polyurethane sheath; E halogen-free low smoke polyolefin sheath; Shielding code P copper wire braided shielding; P1 copper wire wound shielding; P2 copper band shielding; P3 aluminum strip shielding; TP2 concentric conductor + copper band shielding structure; P1-2 double shielding of copper wire winding + copper tape wrapping; PX12 copper band shielding + tin coated copper wire braided double shielding; Armor code 22 steel belt armor; 32 steel wire armouring; Flame retardant code ZR common flame retardant type; WDZ low smoke halogen-free flame retardant type.



Fire retardant broadcasting line ZRHYPY23 zr-hypv ZRHYPV53 zr-hypv22 zr-hpyv23 zr-hyp zr-hypv23 broadcasting line - credit broadcasting line -HYPY23? HYPV? HYPV53? HYPV22? HYP? It adopts full chromatographic insulation and aluminum plastic composite sheath (that is, the longitudinal shielding aluminum belt of the cable is bonded with the sheath to form the seal sheath), which has the characteristics of superior electrical performance and convenient construction

　　（SYV视频电缆、RVVP屏蔽电缆、RVV护套电缆、AVVR信号电缆、SYV射频、）BV塑铜线、BVR塑铜软线、RVSP485双绞屏蔽电缆、RVS双绞线、RVB平行线、RV软线、KVVP控制屏蔽电缆、KVVR控制软电缆、KVV控制电缆、HYA通信电缆、VV电力电缆,RVVP屏蔽线（1～30芯）RVV。

1长距离的线管尽量用整管。1当布线长度超过15米或中间有3个弯曲时，在中间应该加装一个接线盒。因为拆装电线时，太长或弯曲多了，电线无法从穿线管中穿过去。1配电箱内应设动作电流30mA的漏电保护器，分数路控开，保护断路器。保护断路器的工作电流应与终端电器的大工作电流匹配。1像这种悬空的电路是比较少见的，同样要遵循强、弱电分开。如电话老是有杂音，可能就是弱电受到了强电的干扰。1一般情况下，电线线路要与煤气管道、水管，同一平面≥100mm，不同平面≥50mm空调挂机插座安装离地面需2米以上。

　　8）线对颜色区分：2.5mm2线对:红,黑2.5mm2单线:绿0.8mm2线对：⑴．白,白⑵．蓝,蓝⑶．橙,橙⑷．绿,绿⑸．棕,棕⑹．红,红电信局的大对数线序，大对数语音电缆线序，通信电缆线序色谱，HYA通信电缆线序色谱认识表大对数语音电缆线序-大对数音频电话线:大对数电缆: 阻燃大对数电缆：阻燃。

　　煤矿用控制电缆 MKVVMKVV22MKVV32MKVVRMKVVRP MKVVP煤矿用控制电缆产品执行标准：MT煤矿用控制电缆用途：本产品适用于交流额定电压u0/u为450/750V及以下的控制监控回路及保护线路和配电装置中电器仪表的连接线。