康马ZR-KVVRP27X1.0阻燃控制线缆消沉

康马ZR-KVVRP27X1.0阻燃控制线缆消沉

RS485 wiring can be arbitrary layout into star connection with tree, 485 wiring specification is the wiring must be hand in hand, when there is no use 485 hub and 485 relay setting directly into the star connection and connection in a tree, it is easy to cause reflection bus no. Many contractor in 485 wiring, use of star connection and tree, sometimes the very, but sometimes is always appear problem, and it is difficult to find the reason, is usually caused by non-standard wiring. If star connection or tree connection is required due to field connection, the 485 hub and 485 relay of shenzhen fuyongtong technology co., LTD can be used to solve related problems.
The cross section of the control cable is generally no more than 10 square meters, and the power cable is mainly used to transport power, which is generally large. Due to the above all when it comes to the reason, the specifications of the power cable can generally larger, to 500 square feet (normal manufacturer can produce range), again big cross section of the general factory is relatively less, you can do and control cable section generally small, generally not more than 10 square, tell from some cable, power cable according to the demand of power grid more generally for 5 core, and control cable transmission control, some more, according to the terms of more than 61 core, but also can produce according to user re

　　矿用控制电缆电气性能：1、额定电压450/750v2、电缆导体的长度允许工作温度为70摄氏度3、电缆的敷设温度应不低于0摄氏度，推荐的允许弯曲半径；4、无铠装层的电缆，应不小于电缆外径的6倍5、有铠装或铜带屏蔽结构的电缆，应不小于电缆外径的12倍。

　　●型号及名称HYV 铜芯聚乙烯绝缘聚氯乙烯护套市内电话电缆HYY 铜芯聚乙烯绝缘聚乙烯护套市内电话电缆HYV22 铜芯聚乙烯绝缘双钢带铠装聚氯乙烯护套市内电话电缆HYV23 铜芯聚乙烯绝缘聚氯乙烯护套双钢带铠装聚乙烯外护套市内电话电缆HYV32 铜芯聚乙烯绝缘聚氯乙烯护套钢丝带铠装聚氯乙烯外。



　　另外，矿物绝缘电缆是耐火电缆中性能较优的一种，它是由铜芯、铜护套、氧化镁绝缘材料加工而成的，简称MI（minerlinsulatedcables）电缆。该电缆完全由无机物构成耐火层，而普通耐火电缆的耐火层是由无机物与一般有机物复合而成，因此MI电缆的耐火性能较普通耐火电缆更优且不会因燃烧而分解产生腐蚀性气体。

1在高压带电区域内部分停电工作时，人体与带电部分，应保持规定的安全距离，作业时并必须有人监护。变配电室内、外高压部分及线路，停电工作时：1切断有关电源，操作手柄应上锁或挂标示牌。2验电时应戴绝缘手套，按电压等级使用验电器，在设备两侧各相或线路各相分别验电。3验明设备或线路确认无电后，即将检修设备或线路做短路接地。4装设接地线，应由两人进行，先接接地端，后接导体端，拆除时顺序相反。拆、接时均应穿戴绝缘防护用品。

　　3）电缆的敷设温度应不低于0℃；4）电缆的允许弯曲半径为：电缆外径（D）小于25mm者……应不小于4D；电缆外径（D）为25mm及以上者……应不小于6D4、电缆型号、名称及使用范围型号名称使用范围BV铜芯聚氯乙烯绝缘电缆（电线）固定敷设BLV铝芯聚氯乙烯绝缘电缆（电线）固定敷设BVR铜。

　　钢丝铠装通信电缆HYA33HYAT33WDZ-HYA53HYY33HYYT33HYY33。充油通信电缆HYATZRC-HYATWDZ-HYATHYYT。全塑市话电缆执行标准：YD/T。全塑市话电缆结构特点：HYA型市内通信电缆采用全色谱高密度聚乙稀绝缘，铝塑综合护套(即电缆的纵包屏蔽铝带与护套粘结成一体，形成密封护层)，具有电气性能优越，施工方便的特点。
　　3、产品型号、名称及使用范围型号名称使用范围YVV聚氯乙烯绝缘、聚氯乙烯护套仪表用电缆固定敷设，用于仪器、仪表的连接YVVP聚氯乙烯绝缘、聚氯乙烯护套仪表用屏蔽电缆同上，用于要求抗干扰的情况下RVV聚氯乙烯绝缘、聚氯乙烯护套仪表用软电缆用于要求柔软的场合RVVP聚氯乙烯绝缘、聚氯乙烯护套仪表用屏蔽软。

Type KVRP, P1, P3, zr-kvrp, P1, P3 type 450/750v copper core polyvinyl chloride insulated sheathed cable applicable scope: this product is suitable for the rated voltage 450/750v and below transmission and distribution lines. Execution standard: GB9330-1988 and Q/SCT - J02.04-1999 using features: the highest rated temperature of the cable conductor is: PVC insulated cable is 70 ℃, cross-linked polyethylene insulated cable is 90 ℃. Cable laying the environment temperature is not lower than 0 ℃. The maximum bending radius of cable laying is: for unarmored cable, it should not be less than 6 times of the outer diameter of the cable, and the cable with shield layer or copper belt should not be less than 12 times of the outer diameter of the cable.



　　用途：本产品用于计算机和自动化设备连接用电缆，它具有抗干扰、信号衰减小等性能。有普通型、耐寒型等。聚氯乙烯电力电缆执行标准非阻燃型：GB/T 阻燃型：Q/VAHS6-2006用途 本产品适用于交流50Hz额定电压0.6/1KV的线路中，作输配电能之用。

　　多年的“计算机电缆R;DJYPVPR22;DJYPVPR32;DJYJPV,DJVPVP,DJYPVP,DJYJPVP电子计算机电缆DJYVPR;D。2.使用特性1额定电压U0/U为300/500V及以下。

举例：根据你使用的网络摄像机的品牌看单台码流，再去估算一台交换机能接多少台摄像机。比如130万：960p摄像机单台码流通常4M，用百兆交换机，那么就可以接15台(15×4=60M)；用千兆交换机，可以接150(150×4=600M)。200万：1080P摄像机单台码流通常8M，用百兆交换机，可以接7台(7×8=56M)；用千兆交换机，可以接75台(75×8=600M)。这些都是以主流的H.264摄像头为例给大家讲解的，H.265减半就可以了。

Manufacturing technology of frequency converter cable: in the production process of special cable for frequency converter motor, the core extrusion process and cable forming process are the most critical processes. The of the insulation core in the extrusion process of the insulation core will directly affect the electrical energy of the cable.



　　电缆的装卸必须使用吊车或叉车，禁止平运，平放，大型电缆安装时须使用放缆车，以免电缆受外力损伤或因人工拖动而擦伤。电缆如因故不能及时敷设时，应将其放在干燥地方贮存，防止日光爆晒，电缆端头进水等。 注意：电线电缆安装应熟悉电线电缆性能的安装人员或专职技术人员担任，如仍有不清事项，请向相关技术部门或我厂技术部咨询。