凤阳矿井下各种移动电器的电源连接线心烦

凤阳矿井下各种移动电器的电源连接线心烦
　　接地引出线要求采用我镀锡编织铜线，和电缆铜带连接时应用铬铁锡焊，不宜用喷灯封焊，以免烧损绝缘。 ③三相铜带屏蔽应分别与地线相连，注意屏蔽接地线和钢铠接地线应分别引出，相互绝缘，焊接地线的位置应尽量靠下。
　　电缆任一绝缘线芯的电感与电阻之比均不大于50uH/Ω。辐射电磁场在频率20-200MHz的范围内，场强为120dB（7mv）的电磁场中，电缆线芯内感应强度小于50dB。缆抗外磁场能力：在频率为50Hz，强度为400A/m的外界磁场下，当电缆的一端输入频率为1KHz，电流强度在0-100mA变化时，电缆的另一端输入信号变化值不超过±50uA。
由于含卤阻燃电缆（包括阻燃电缆、低卤低烟阻燃电缆）在燃烧时会释放具有腐蚀性的卤酸气体，大大阻碍消防工作从而耽误救火时间并加剧火势蔓延，因此在人口密度较高的公众场所应尽量设计选用无卤低烟阻燃电缆。在人口密度较小的作业区可以选用任意一种阻燃电缆。阻燃电缆分为A、B、C3类，其中A类阻燃电缆性能较B、C类更优，价格也贵。设计人员提供订货清册时应标明阻燃电缆的类别。从外观上无法区分阻燃电缆的A、B、C类别，只有靠制造厂家进行供货保证，因此在设计选用时应慎重选择电缆制造厂家。凤阳矿井下各种移动电器的电源连接线心烦

　　IEC/BS4066-1阻燃等级（单根电线或电缆垂直燃烧测试FlameTestOnSingleVerticalInsulatedWires/Cables）这是单根电缆的阻燃标准。阻燃电缆◎IEC/BS4066-3阻燃等级（成束电线或电缆垂直燃烧测试FlameTestOnBunchedWires/Cables）这是成束电缆的标准。



Precautions for installation of power cables: keep 2m distance when the cable is installed in parallel with the thermal pipe, and 0.5m should be maintained when crossing. The cable shall be installed at a distance of 0.5m in parallel or across other pipelines. When the cable is directly buried and installed, the buried depth of 1-35kv cable is not less than 0.7m. When 10KV and below cables are installed in parallel, the net distance between them shall not be less than 0.1m and 10-35kv shall not be less than 0.25m. The distance of cross installation is not less than 0.5m. Cable laying temperature is not lower than 0 ℃, bending radius: multi-core cable or 15 (D + D), a single cable 20 or more (D + D), (D for cable diameter, D) for the conductor diameter. 6 kv and above cable joint: (1) installing a cable terminal head, must be stripped semiconductor electric shielding layer, operation shall not damage the insulation, should avoid mark uneven situation, when necessary use sand paper to grind; The shield end should be flat and the graphite layer (carbon particles) should be cleaned. (2) plastic cable end copper tape screened and armor must be good grounding, the short circuit also follow this principle, avoid unbalanced three-phase run ShiGang armoured end produce inductive electromotive force, and even "lighter" and accidents such as burning sheath. It is required to use my tinplate to braid copper wire for grounding lead. When connecting with the cable copper belt, it should be welded with chromium-iron tin. The shield of three-phase copper tape should be connected with ground wire respectively. Note that the shielded ground wire and steel armor ground wire should be separately drawn out and insulated from each other. The position of the welded ground wire should be as low as possible. Basic re for cable terminals and intermediate joints: a. good conductor connection; B. The insulation is reliable, and it is recommended to use irradiated cross-linked heat-shrinkable silicone rubber insulation materials; C. good sealing; D. sufficient mechanical strength to meet various operating conditions. The end of the cable must be used to prevent erosion of water and other corrosive materials, so as to prevent breakdown due to the aging of the insulation layer caused by water trees. Crane or forklift should be used for the loading and unloading of cables. It is forbidden to run flat or lay flat. For installation of large cables, cable laying cart should be used to avoid external damage or abrasion caused by manual dragging. If the cable cannot be laid in time for some reason, it should be stored in a dry place to prevent sunlight from exploding and water entering the end of the cable. Note: the installation of wire and cable should be done by the installation personnel or full-time technical personnel familiar with the performance of wire and cable. If there are still unclear matters, please consult the relevant technical department or the technical department of our factory.

MOS管型防反接保护电路利用了MOS管的开关特性，控制电路的导通和断开来设计防反接保护电路，由于功率MOS管的内阻很小，现在MOSFETRds（on）已经能够做到毫欧级，解决了现有采用二极管电源防反接方案存在的压降和功耗过大的问题。极性反接保护将保护用场效应管与被保护电路串联连接。保护用场效应管为PMOS场效应管或NMOS场效应管。若为PMOS，其栅极和源极分别连接被保护电路的接地端和电源端，其漏极连接被保护电路中PMOS元件的衬底。

无卤低烟阻燃电缆和含卤阻燃电缆相比，有低腐蚀、低烟的优点，但电性能及机械性能明显降低，所以在进行电缆敷设时，无卤低烟阻燃电缆应较含卤阻燃电缆有更大的弯曲半径。在进行电缆敷设设计时，不宜将非阻燃电缆和阻燃电缆并列敷设，不宜将不同阻燃类别的阻燃电缆并列敷设。

阻燃电缆标准：电缆涉及火灾安全的主要技术指标是CO2电缆的阻燃性、烟雾的密度和气体的有毒性。美国防火标准较关注前两个问题，但是欧洲和美国对火灾安全有着完全不同的观点。

美国传统的概念认为：火灾的根源在于一氧化碳（CO）毒气的产生以及其后的燃烧过程中CO转化为CO2的热释放，因此，控制燃烧过程中的热释放量可减少火灾的危害。欧洲传统以来深信：在燃烧中产生的卤酸（HCL）释放量、气体腐蚀性、烟雾浓度及气体毒性是决定人们能否安全脱离火灾现场的主要因素。

HYAT23 armoured communication cable USES: armoured communication cable mechanical protective layer can be appended to the structure of the cable, with the mechanical strength of the cable, antierosion capability, is vulnerable to mechanical and vulnerable to erosion area and design of telephone cable. Any kind of laying can be adopted, which is more suitable for direct buried laying in rock area. Armored communication cable structure: 1. Basic cable: any filled and unfilled cable with single sheath or double sheath structure. ? 2. Armored communication cable mechanical protection layer: type 53 adopts 0.15mm thick corrugated steel belt, which is longitudinal wrapped on the basic cable and overlapped on both sides. The surface of the steel belt is coated with plastic to prevent corrosion and water intrusion. The type 23,22 has similar performance with double steel band wrapping. 3. Armored communication cable sheath: black high-molecular weight low-density polyurethane or polyurethane sheath. Sheath thickness may depend on the basic cable outer diameter.

　　使用时，建议铠装层两端接地，内层屏蔽一端接地。性阻抗为100Ω的双绞屏蔽电缆STP-100Ω(forFF&PROFIBUS-PA)onepair18AWG则应用于FF、PROFIBUS-PA总线，常用18AWG导体。



　　二：产品执行标准Q/HHTZH007.1阻燃性能试验执行GB规定三：使用特性1．交流额定电压：U0/U0.6/1KV高工作温度：105℃低环境温度：固定敷设-40℃2．电缆安装敷设温度应不低于-25℃。

为了评定线缆的阻燃性能优劣，国际电工委员会分别制定了IEC60332-1、IEC60332-2和IEC60332-3三个标准。IEC60332-1和IEC60332-2分别用来评定单根线缆按倾斜和垂直布放时的阻燃能力（国内对应GB12666.3和GB12666.4标准）。IEC60332-3（国内对应GB12666.5-90）用来评定成束线缆垂直燃烧时的阻燃能力，相比之下成束线缆垂直燃烧时在阻燃能力的要求上要高得多。

IEC60332-1/BS4066-1阻燃等级（单根电线或电缆垂直燃烧测试FlameTestONSingleVerticalInsulatedWires/Cables）

RC滤波电感器的成本高、体积大，所以在电流不太大的电子电路中常用电阻器取代电感器而组成RC滤波电路。同样，它也有L型；π型。稳压电路交流电网电压的波动和负载电流的变化都会使整流电源的输出电压和电流随之变动，因此要求较高的电子电路必须使用稳压电源。稳压管并联稳压电路用一个稳压管和负载并联的电路是简单的稳压电路。R是限流电阻。这个电路的输出电流很小，它的输出电压等于稳压管的稳定电压值VZ。

MKYJVP MKYJV cable, cable, MKYjVP2 cable, MKYJV22 cable, MKYJV32 cable, MKYJVR cable, MKYJVRP cable, MKYJVP22 cable and other types of flame retardant control cable, recommend some cable 2,3,4,5,7,8,10,12,14,16,19,24,27,30,37,44,48,52,61 core.