煤矿用控制电缆MKVV7X1.5榕城定做HBV2X0.5电线结构与格浓重

煤矿用控制电缆MKVV7X1.5榕城定做HBV2X0.5电线结构与格浓重

　　DJYP2V(R)P2-22聚乙烯绝缘铜带绕包分屏总屏聚氯乙烯护套钢带铠装计算机用屏蔽(软)电缆。DJYVP3(R)-22聚乙烯绝缘铝塑复合带绕包总屏聚氯乙烯护套钢带铠装计算机用屏蔽(软)电缆。DJYP3V(R)22聚乙烯绝缘铝塑复合带绕包分屏聚氯乙烯护套钢带铠装计算机用屏蔽(软)电缆。



　　字母R代表软线字母V代表绝缘体聚氯乙烯（PVC）比如：RVV2*0.5就是2根0.5平方毫米的线外加一层外护套，护套的作用是：1、保护电缆内护层不受机械损伤和化学腐蚀；2、增强线缆机械强度。RVV电缆主要用途：应用于电器、仪表和电子设备及自动化装置用电源线、控制线及信号传输线，具体可用于防盗报警系统、楼宇对讲系统等。

　　基带电缆仅仅用于数字传输，数据率可达10Mbps。同轴电缆以硬铜线为芯，外包一层绝缘材料。这层绝缘材料用密织的网状导体环绕，网外又覆盖一层保护性材料。有两种广泛使用的同轴电缆。一种是50欧姆电缆，用于数字传输，由于多用于基带传输，也叫基带同轴电缆；另一种是75欧姆电缆，用于模拟传输，即宽带同轴电缆。

|MHYV mine cable |MHYVR mine cable |MHYVP mine shielded cable |MHY32 mine cable |MHYVRP mine shielded cable | mine monitoring cable?



Spin cassette XF5-273 communication cable transfer box, adopting advanced technology at home and abroad, in accordance with the international advanced standard production in the eighty s of cable wiring e, for the city, the town of telecommunication network backbone cable and wiring cable transfer. Features: 1. The connection jumper adopts rotary clamp-type connection and is sealed with silica gel on the metal clip, because it is not only reliable and durable, but also easy to operate and repair without stripping. 2. The wiring terminals in the handover box shall be arranged in 25 pairs as a basic unit, consistent with the basic units of the local telephone cables and marked with Numbers on the terminals to facilitate construction and maintenance. 3. The structure, arrangement and installation dimensions of the wiring modules are exactly the same as those of 3M products and can be used for each other. 4. The box body is treated by electrostatic spraying, beautiful and generous, with clear lines, good anti-corrosion and waterproof performance and long service life. Main technical parameters: the environment temperature: - 40 ℃ ~ + 65 ℃ atmospheric pressure: 70 ~ 106 kpa relative humidity: 95% or less is random ends and insulation resistance between terminals and ground > 5 x 104 Μ Ω. When connecting any two ends and any terminals and grounding to 1000V ac, there shall be no breakdown or flying arc in 1min. Contact resistance between wire and terminal < 5 x lO - 3 Ω.

从而控制外部两条独立的收发信号线RXD(P3.0)、TXD(P3.1)，同时发送、接收数据，实现全双工。串行口控制寄存器SCON(见表1)。表1SCON寄存器表中各位(从左至右为从高位到低位)含义如下。SM0和SM1：串行口工作方式控制位，其定义如表2所示。表2串行口工作方式控制位其中，fOSC为单片机的时钟频率;波特率指串行口每秒钟发送(或接收)的位数。SM2：多机通信控制位。该仅用于方式2和方式3的多机通信。

　　弯曲半径不低于电缆外径的15倍（敷设时），且适用于任何水平差的干扰信号工程专用电缆PTYA22PTY23PTY22PTYAH23PZYA23PZYA22PZY23PTYA23、PTYA22铁路工程专用信号电缆电缆芯数（芯）：4、6、8、9、12、14、16、19、21、24、28、30、33、37、。

　　 b.周围环境温度：25℃ c.土壤热阻系数：1.0K•m/Wd.直埋深度：0.7m e.不同环境温度下载流量校正系数：环境温度（℃）1520253035校正系数1.111.051.000.940.88 ①电缆导体的长期允许工作温度：≤90℃ ②短路时（长持续时间不超过。
　　5种主色：白色、红色、黑色、黄色、紫色5种次色：兰色、桔色、绿色、棕色、灰色通信电缆线序色谱认识举例说明：10对通信电缆色谱线序表1对—白兰2对—白桔3对—白绿4对—白棕5对—白灰6对—红兰7对—红桔8对—红绿9对—红棕10对—红灰20对通信电缆色谱线序表1对—白兰2对—白桔3对—白绿4对—白棕5对。


Flame retardant cables and fireproof cables: the difference between the average person is very easy to confuse the concept of flame retardant cables and fireproof cables, although there are many more flame retardant cable applies to the advantages of chemical enterprise, such as low, low smoke, non-halogen, but in general, fire-resistant cable can replace flame retardant cable, and flame retardant cables can't take place of fire-resistant cable.

　　缆芯包带：缆芯用聚脂薄膜带绕包。屏蔽：用0．2mm厚的双面涂塑铝带轧纹(或不轧纹)纵包于缆芯包带外，搭接处粘合。护套：黑色低密度聚乙烯。可提供双护套电缆。识别和长度标记：电缆外表有性识别标记，标记间隔不大于1m，标记内容有：导线直径、线对数量、电缆型号、制造厂厂名代号及制造年份，长度标记以间隔不大于1m标记在外表面上。

　　型号及名称：序号型号名称1KFF氟塑料绝缘和护套控制电缆2KFFP氟塑料绝缘和护套屏蔽控制电缆3KFFR氟塑料绝缘和护套控制软电缆4KFFRP氟塑料绝缘和护套屏蔽控制软电缆5KFV氟塑料绝缘聚氯乙烯护套控制电缆6KFVP氟塑料绝缘聚氯乙烯护套屏蔽控制电缆7KFVR氟塑料绝缘聚氯乙烯护套控制软电缆8K。

尤其是微小信号的测量，信号地通常需要采取隔离技术。屏蔽电缆的屏蔽层主要由铜、铝等非磁性材料制成，并且厚度很薄，远小于使用频率上金属材料的集肤深度，屏蔽层的效果主要不是由于金属体本身对电场、磁场的反射、吸收而产生的，而是由于屏蔽层的接地产生的，接地的形式不同将直接影响屏蔽效果。对于电场、磁场屏蔽层的接地方式不同。可采用不接地、单端接地或双端接地总结：单端接地:屏蔽电缆的单端接地对于避免低频电场的干扰是有帮助的。

　　 IA-DJVP2V2R IA-DJYP2V2R IA-DJYJP2V2R 本安型、本安型、铜塑复合膜分对屏蔽、总屏蔽软结构 。IA-DJVP3VP3R IA-DJYP3VP3R IA-DJYJP3VP3R 本安型、本安型、铝塑复合膜分对屏蔽、总屏蔽软结构。

　　100对及以上线对的电缆加有1％的预备线对，但多不超过6对。缆芯内的间隙用石油膏填充。5、缆芯包带：用聚脂薄膜带绕包。6、屏蔽：铜丝屏蔽或用轧纹（或不轧纹）金属带，金属带纵包于通信电缆缆芯包带之外。7、护套：蓝色低密度聚乙烯。



RS485 cable product description: Characteristic impedance of 100 ohms, conductor is 2 * 2 * 24 awg multi-strand tin electrolytic copper wire twisted and become, insulating sheath like installation of design and color recognition, overall aluminum foil/polyester belt shielding, additional independent stranded tinned copper wire grounding conductor, industrial gray PVC outer sheath, the standard 1 to RS - 485 communication cable, the characteristic impedance of 120 ohms, conductor is 2 * 24 awg stranded tinned copper wire, PE insulation, covered with aluminum foil/polyester composite with + 90% tin plated copper wire cover, double shielding with independent grounding conductor is RS - 485 communication cable.

It is composed of different material conductors in metal sleeves with insulating materials, which are processed into a flexible solid assembly.