VVRP6X0.5电缆格肇源良心厂家RVVP6X0.75线缆直销格舒畅

VVRP6X0.5电缆格肇源良心厂家RVVP6X0.75线缆直销格舒畅

Cable conductor of long term working temperature should be allowed no more than 70 ℃, the cable in use should be to prevent high temperature radiation or; The environment temperature under installation should not below 0 ℃.



　　识别和长度标记：电缆外表面有性识别标记，标记间隔不大于1m，标记内容有：导线直径，线对数量，电缆型号，制造厂厂名代号及制造年份，长度标记以间隔不大于1m标记在外表面上，但与上述标记错开。 特点：1交接跳线采用旋转卡夹式接线，并在金属卡件上用硅胶密封，因不仅接续可靠，经久耐用，具有不用剥线、操作检修方便。

　　8）线对颜色区分：2.5mm2线对:红,黑2.5mm2单线:绿0.8mm2线对：⑴．白,白⑵．蓝,蓝⑶．橙,橙⑷．绿,绿⑸．棕,棕⑹．红,红ˎ̥HYA553铜芯实心聚烯烃绝缘挡潮层聚乙烯护套单层纵包轧纹钢带铠装聚乙烯套市通信电缆。

　　RVVP、KVVP这类的线材，虽然有屏蔽网，但其PVC绝缘的介质损耗实在让人无法忍受，更难实现高速远距离传输。当高速、远距离通信，或者处于干扰恶劣的工业环境下，选择传输介质就显得十分重。采用阻抗相匹配的RS485电缆有利于降低信号的回波反射；其双绞对称、多重隔离屏蔽等独特的结构，通过正确的接地，提高了信道的抗干扰性能；其高频低衰减的特性，可实现信号长线传输距离Zui大化。



　　例如：①煤矿用铜芯聚乙烯绝缘聚氯乙烯护套通信电缆，2芯1.5mm2(1/1.38)或7芯0.75mm2(7/0.37)，适用于固定场合使用和2对1.5mm2(48/0.2)，适用于移动场合使用，表示为：MHYV1x2x1.5(1/1.38)或MHYV1x7x0.75(7/0.37)或MHYV1x7x。

亦即，步进电机的驱动脉冲波连续自动扫频，每次记录频率分析的结果用三维表示。Y(倾斜）轴表示步进电机脉冲频率，X(横）轴表示振动频率，Z(纵）轴表示振动加速度。由此可以看出，何处的驱动脉冲，频率多少时，会产生的振动大小，一目了然，易于分析振动结果。根上振动分析图，从振动大的地方看到，驱动脉冲的基波频率造成振动成分Zui大，且出现的振动点为其偶次谐波，180pps附近的振动为振动加速度与转子及其负载系统的自然频率的共振。

　　2、成品电缆经受交流50Hz、3kV/5min电压试验不击穿。它的特性：1、交流额定电压：U0/U450/750V。2、电缆导体长期允许Zui高工作温度：180℃。3、Zui低环境温度：固定敷设-60℃，非固定敷设-20℃。

Technical indicators: polyvinyl chloride insulated cables long-term allowed working temperature over 70 ℃, the cable temperature under installation should not below 0 ℃, outer diameter (D) is less than 25 mm cable bending radius is allowed, should not be less than 4 times of cable diameter; The outer diameter (D) shall be the allowable bending radius of 25mm and above cables, and shall not be less than 6 times of the outer diameter of cables.
　　视频线SYV-75-5,SYV-75-3,电源线RVV,屏蔽线RVVP供应视频线SYV-75-5,SYV-75-3,电源线RVV,屏蔽线RVVP本公司郑重声明：1、签订产品质量保障书，承诺-不合格产品绝不出厂。

　　0.5-1.5mm21-84对（3线组）用于电子控制装置、自动化系统、数字验检、计算机回路及其它一般工业计算机检测装置上。例如：ZR-DJYPVZR-DJYPVP等（2）铠装型（钢带铠装）电缆需在型号右下角加代号“22”例如：DJYPV22DJYPVP22等。



　　KVV32聚氯乙烯绝缘，细钢丝铠装聚氯乙烯护套控制电缆敷设在室内、电缆沟中、管道、竖井内及地下，能承受一定的拉力作用。PYYPTYY聚乙烯绝缘乙烯护套铁路信号电缆。PYAPTYA聚乙烯绝缘挡潮综合护套（铁路）信号电缆。

　　此电缆便于安装架线，节约工程成本。1、名称:低烟无卤阻燃计算机电缆2、本产品适用于额定电压450/750V及以下电子计算机系统(DCS)的数据传输和抗干扰要求较高的检测仪器仪表，以及其他自控系统的弱信号连接、传输。

电动机的过载保护，作为电机保护的一项重要措施应用广泛，它的原理就是电动机过载运行时，电流增加，绕组过热，若时间过长就会损坏绝缘。过载保护的功能是，及时切断电源，限制电动机过热时间，以防绝缘损坏。它分为两种方式，一种是热效应元件动作控制触点的接通和断开，其典型代表是使用双金属片动作的普通热继电器。另外一种是使用过电流检测电路直接检测电流大小，Zui终驱动电磁继电器或固态继电器断开电源其典型代表是过电流继电器和各种类型的电动机保护器。

　　ˎ̥NH-KFV电缆，KFVR电缆优势说明：详细说明:NH-KFV电缆，KFVR电缆矿用电缆是煤矿用电缆的简称，矿用电缆均为阻燃电缆，都应经过安标国家矿用产品安全标志中心颁发矿用产品安全标志证书。U型（M型）煤矿用橡套电缆本产品按GB/T《矿用橡套软电缆》、MT《煤矿用阻燃电缆》生产，同时还可根据用户需要按国际电工委员会推荐标准IEC、英国标准、德国标准及美国标准生产。


　　常被用于那些对传输的信号要求很高的场合。4、产品使用范围：本产品适用于交流额定电压450/750V及以下的动力、日用电器、仪器、仪表、电讯设备，照明电路以及自动化装置的固定敷设，连接用软线，安装用软线以及干扰较强的场合用屏蔽电线。

Precautions for installation of power cables: keep 2m distance when the cable is installed in parallel with the thermal pipe, and 0.5m should be maintained when crossing. The cable shall be installed at a distance of 0.5m in parallel or across other pipelines. When the cable is directly buried and installed, the direct buried depth of 1-35kv cable is less than 0.7m. When 10KV and below cables are installed in parallel, the net distance between them shall not be less than 0.1m and 10-35kv shall not be less than 0.25m. The distance of cross installation is not less than 0.5m. Cable laying temperature lower than 0 ℃, bending radius: multi-core cable or 15 (D + D), a single cable 20 or more (D + D), (D for cable diameter, D) for the conductor diameter. ? 6KV and above cable connector:? When installing the terminal head of the cable, the semiconductor electrical shielding layer must be stripped off. During operation, the insulation shall not be damaged. The shield end should be flat and the graphite layer (carbon particles) should be clean. (2) plastic cable end copper tape screened and armor must be good grounding, the short circuit also follow this principle, avoid unbalanced three-phase run ShiGang armoured end produce inductive electromotive force, and even "lighter" and sheath and other accidents. It is required to use my tinplate to braid copper wire for grounding lead. When connecting with the cable copper belt, it should be welded with chromium-iron tin. ? The shield of three-phase copper tape should be connected with ground wire respectively. Note that the shielded ground wire and steel armor ground wire should be separately drawn out and insulated from each other. The position of the welded ground wire should be as low as possible. Basic re for cable terminals and intermediate joints: a. good conductor connection; B. The insulation is reliable, and it is recommended to use irradiated cross-linked heat-shrinkable silicone rubber insulation materials; C. good sealing; D. sufficient mechanical strength to meet various operating conditions. The end of the cable must be used to prevent water and other corrosive materials from corroding, in order to prevent the water tree caused by the aging of the insulation layer and breakdown. Crane or forklift should be used for the loading and unloading of cables. It is forbidden to run flat or lay flat. For installation of large cables, cable laying cart should be used to avoid external damage or abrasion caused by manual dragging. If the cable cannot be laid in time for some reason, it should be stored in a dry place to prevent sunlight from exploding and water entering the end of the cable. ? Note: the installation of wire and cable should be familiar with the performance of wire and cable installation personnel or full-time technical personnel, if there are still unclear matters, ball related technical department or technical department of our factory.

　　使用特性：1、额定电压：交流Uo/U；450/750V2、工作温度：序号1～4-60～+200℃序号5～14-15～+105℃3、绝缘电阻（20℃）不低于50MΩ•km4、导体线芯直流电阻（20℃）符合GB规定5、无铠装电缆允许弯曲半径不小于电缆外径的6倍，铠装电缆允许弯曲半径不小于电缆外径的12倍。